Results 1 to 5 of 5

Thread: Output Profiles & Calibration on FS100

  1. #1
    Join Date
    Apr 2013
    Posts
    13

    Default Output Profiles & Calibration on FS100

    I have Ricoh MPC 3003, and I bought Fiery e-22c, with new version of software FS100.

    I wanted to change/ create Custom Output Profile and calibrate it with ColorCal associate for one paper type.
    That I did easily on previous versions on Fiery controllers.

    This is procedure I need to do:

    1. Set Max Density in Output Profile
    2. Do Calibration with ColorCal for one paper type and Output Profile I adjusted.


    PLEASE ADVICE

  2. #2
    Doyle is offline Fiery Forum Expert Contributor Doyle is on a distinguished path
    Join Date
    Apr 2010
    Posts
    256

    Default

    Seems to me your going about this backwards.

    You need to do a new calibration first. You can adjust density targets up or down when doing the new calibration. If you want to adjust an existing calibration you can export the measurements and create a new calibration and import the calibration as a target and adjust your target density.

    After calibration you then create an output profile. The maximum density in the output profile can be edited as anytime but only less than 100% not more.

  3. #3
    Join Date
    Apr 2013
    Posts
    13

    Default

    Maybe I going backwards because of older version of Fiery software.
    Exactly where I stacked.

    So, what I need is to set Max Density lower than 100% is. For Example if measured density is 1.32 I need to set for about 1.1.

    Problem is that I didn't find the way in newer version of Fiery FS100.

    Here is Screenshot of what I looking for
    Name:  Screen Shot 2016-06-17 at 11.58.54 AM.png
Views: 1545
Size:  44.7 KB

    This is the place in Color Editor where I could enter values I want.

    If you can to send me any kind of instruction how to do I will be very much appreciative

  4. #4
    Doyle is offline Fiery Forum Expert Contributor Doyle is on a distinguished path
    Join Date
    Apr 2010
    Posts
    256

    Default

    On the calibration side it was explained to you in this post.
    http://fieryforums.efi.com/showthrea...utput-Profiles

    On the Profile side, have tried to achieve what you want by editing the 100% output in the profile?

  5. #5
    Join Date
    Apr 2013
    Posts
    13

    Default

    Thanks!!!

    Problem Solved!

    I just did import and export measurement and at the end create what I wanted.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts