Results 1 to 2 of 2

Thread: Error Message "40" and then "EE" when using Fiery Clone Tool for Embedded v. 2.1

  1. #1
    Join Date
    Aug 2009
    Posts
    10

    Default Error Message "40" and then "EE" when using Fiery Clone Tool for Embedded v. 2.1

    Hi,

    We are using the Fiery Clone Tool for Embedded v. 2.1 to create an initial clone of a Fiery C75EFI. We have appeared to successfully prepare the USB disk. It is 4 GB. (We tried a 16 GB USB but the USB tool could not copy the ISO file to it.)

    We follow the instructions in the User Guide and immediately after moving switch 2 to the up position, we receive the "40" and then "EE" error. The user guide indicates that "40" is used for the Restore operation...we are trying to perform an initial back up. HELP!!!

  2. #2
    Join Date
    Aug 2009
    Posts
    10

    Red face Resolution

    The Fiery is installed upside down. The words and the letters are VERY small. Actions need to be performed opposite of how the diagram and instructions appear in the documentation to match how the Fiery is installed on the back of the device.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts