+ Reply to Thread
Results 1 to 3 of 3

Thread: How to set rip and hold on Version 7.5

  1. #1
    Join Date
    May 2014
    Posts
    4

    Default How to set rip and hold on Version 7.5

    My system crashed and when they re-installed it I no longer have the rip and hold feature. I have to go to print options then advanced to rip and hold. Is there an easy way to set it up so all jobs are held until I release them?
    Thank you for your time.

  2. #2
    Join Date
    Jul 2010
    Location
    Atlanta, GA
    Posts
    87

    Default How to set rip and hold

    You can set the driver defaults to Rip and Hold and the jobs will come in to the VE in a held status. The print driver is always the master. You can also set VE engine defaults to hold incoming jobs. Right click the engine in PSM and select Engine defaults and place a check in hold incoming jobs. Realize that the print driver can override this setting it is the master. If the driver is set to "use default settings" then it will honor PrintStation Manager engine defaults.

    Thanks,
    Ken
    MicroPress support

  3. #3
    Join Date
    May 2014
    Posts
    4

    Default

    Thank you so much Ken.
    I have asked the IT guys at both businesses and no one could fix it. I had gone into VE but never thought about the print driver. They must not have either.
    Thanks again it will save me so much time.

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts