Results 1 to 3 of 3

Thread: Another CWS conflict with layout gangup

  1. #1
    Join Date
    Sep 2013
    Posts
    34

    Default Another CWS conflict with layout gangup

    Just found another conflict in command workstation ...

    When printing a multi-page document, if you use layout tab to gang up a job (eg. 2 up on an A4) you can no longer go and choose just to print one page, you have to print all, even if it isn't set to duplex

    Is there a reason for this that I am missing!?

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    343

    Default

    When you are making a gangup layout, you are positioning more than one page on a sheet of paper or, in the case of Step and Repeat, placing the same page multiple times. If you want to print a specific range, you can specify the range of sheets you want to print in the Job Info tab of Job Properties. For example, if you want to print only page 1 of the job in a Step and Repeat layout, set your Gangup, Step and Repeat parameters with duplex off in the Layout tab, then in Job Info, select Sheets in the Print Range and enter 1 to print only sheet 1.

  3. #3
    Join Date
    Sep 2013
    Posts
    34

    Default

    Thanks Bob, yes this works thank you.

    We did have to update to the most current version of CWS to help solve it as well, because the sheets were greyed out as well.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts