Closed Thread
Results 1 to 3 of 3

Thread: Patches

  1. #1
    Join Date
    Apr 2010
    Posts
    12

    Default Patches

    Where do I find the area to load the MicroPress patches into the Fiery?
    Thanks, tva

  2. #2
    Join Date
    Jul 2010
    Location
    Atlanta, GA
    Posts
    88

    Default Patches

    Hi TVA,
    In the PrintStation Manager (PSM), on the left hand pane expand the Virtual Printer (VE) and double-click (or right-click) the Print Engine (PE). This open the Engine Info window. Click on the Settings tab and click Install Patch.

    Here are some additional instructions for the patches.
    - From the folder which MicroPress was installed browse to the sub-folder \firmware\EnginePatch\PrintStation
    - Select the .ps patch file to install and click Open.
    NOTE: Only install patches as directed by the MicroPress Service Bulletin. Installing a patch other than that which is approved may render the controller unstable.
    - Wait a couple minutes for the patch file to be processed. There will not be any indication of this process.
    - Reboot the controller.
    - Repeat these steps for additional patches as directed by the MicroPress Service Bulletin.
    NOTE: The controller MUST be rebooted after each patch installation!

    Thanks,
    MicroPress TechSupport

  3. #3
    Join Date
    Apr 2010
    Posts
    12

    Default Thanks Rich

    Thanks Rich

Closed Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts