Results 1 to 2 of 2

Thread: Imposition/Image Shift issue

  1. #1
    Join Date
    Nov 2013
    Posts
    8

    Default Imposition/Image Shift issue

    I'm having an issue where I'm trying to print postcards with a database. I do them ganged up four on a page with multi-record collate. Everything looks fine. I then go into properties for the new file and apply an Image shift on the back, bringing the image down about three millimeters. If I print it out, everything looks fine.

    The issue comes if I try to save these settings as a preset and use them again, then the bottom left image (R4-P2, R8-P2, R12-P2, etc.) on the back is shifted like it should, but the other three images are not. If I go through the steps from scratch, it does fine. It's just when I try to use a preset. Since I do this kind of job at least once a week, doing it from scratch every time would be a nuisance, especially since I didn't have this problem until we got a new Fiery system just a couple weeks ago and this problem started.

  2. #2
    Join Date
    Nov 2013
    Posts
    8

    Default

    Correction, I just went through doing the steps from scratch. When I apply the image shift during this process, it has the same effect of not shifting the other three images. Any help greatly appreciated.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts