Results 1 to 3 of 3

Thread: Calibrator not working on win 7 64 bit OS

  1. #1
    Join Date
    Oct 2010
    Posts
    8

    Default Calibrator not working on win 7 64 bit OS

    Getting an error message that the calibrator is in use by the administrator.. I have tried both the cws 4.x & 5.x & I get the same message whenever I invoke the calibrator. This is for a Xerox 700 with an integrated fiery controller.

  2. #2
    Join Date
    May 2009
    Location
    Minneapolis, MN
    Posts
    404

    Default

    Hello,

    This is usually caused by someone else running Calibrator. Are you certain there is no one else running Calibrator at the engine or in CWS?

    If someone unknown is running Calibrator, rebooting or restarting the controller should free up Calibrator. Have you tried rebooting?

    Thank you,
    Bruce

  3. #3
    Join Date
    Oct 2010
    Posts
    8

    Default Resolved

    Hey Bruce,
    I rebooted the fiery & now can run the calibrator from the 64 bit systems..
    thank you very much

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts