View Full Version : JobFlow Installation - Change IP Address of the Server

11-27-2014, 02:25 AM
During installation of JobFlow I didn't see the question on which server to run JobFlow. So after Installation it wanted to get access to 192.168.xxx.xxx, which is the IP Address of one of the VMware Ports on the system. After disabling both VMware ports the JobFlow software ran OK. Where can I set the right Server IP Adress, or conect to the right Network Card, so I can enable both VMware ports again?

12-01-2014, 02:29 PM
Fiery JobFlow runs on top of Apache so we might need to tweak http.conf Can you contact me at hans.sep [at] efi.com to discuss further?