PDA

View Full Version : x3ety2 dead help



yan gregoire
05-22-2013, 04:31 AM
ikon tech
fiery x3ety2 connected to a IKON konika not working getting C0 on led display
can someone tell me what is C0.
and whats not working
not listed on service manual and on franx motherboard look up on the net nothing.

no post at start up with moniter
cant reinstall the OS
swapt dimm hdd and interface pwb.

please help from someone

thanks

Scott_W
05-22-2013, 06:23 AM
What copier model is the X3eTY2 connected to and what is Part Number and Model number off the Fiery's case sticker?

I looked up that code:

Early chipset initialization:
-Disable shadow RAM
-Disable L2 cache (socket 7 or below)
-Program basic chipset registers

Since "C0" code happens right away, and you get nothing on monitor during POST, it looks like a failed motherboard or CPU.

Did you reseat CPU, replace DIMM(s)?

yan gregoire
05-22-2013, 07:12 PM
model x3ety2-10
part number 45059928
on a cpp-650 from ikon

i did a DIMM swap with other unit hdd and interface pwb..
didn't remove the cpu from motherboard
at start up it shows FF C1 and locks at C0.
so you think CPU or motherboard !

what is my next step?
thanks for the fast reply

Scott_W
05-23-2013, 07:54 AM
You still may be able to get Ikon (now Ricoh) to replace that motherboard (kit part number 45073491). Though that Fiery is no longer officially supported by them - or anyone else, for that matter.
An alternative may be to find another used one (with same part number on sticker - 45059928)

Another possibility, since that copier is a re-badged KM C6500 / 6501, is to find a used KM Fiery controller:
IC-408 X3eTY2 v2.0 System Software
IC-303 S450 v3.xx System Software
IC-305 Pro80 v3.xx System Software

These controllers would work with CPP650 copier

If, you could buy one of these from a KM dealer, perhaps you could get support for the copier AND the Fiery as well